A short while ago, one of my Fulvia contacts asked me to comment on this ebay item. From the item comes the picture above; it's a turbo set-up for a Fulvia!
If you click on the link you will find some more pictures.
With my experience at Evolution Engineering which specialised in Lancia and FIAT, I have to say that this "kit" appears to have used various FIAT components - almost certainly from a Uno Turbo. At a glance it would seem to me that the problems would be formidable. Here are some of those that spring to mind:
- With 9.5/1 or 10.5/1 compression (1300/1600) one could run very little boost without meltdown ensuing rapidly, so special pistons would be required to lower the compression ratio.
- This problem would be exacerbated by the necessarily long inlet pipe (where would you run it?) which would mean lag and raised inlet temperatures
- Pressurised carburettor(s) would be very difficult to arrange, so electronic injection/management would be required. To install this would not be trivial; the cheapest approach would probably be to use a plenum chamber and single throttle body scrounged from another Uno Turbo; then of course there's mounting the sensors - oh yes and the small matter of calibration.
- Routing the exhaust, always a problem on a Fulvia would be rather tricky... and how long would that welded-up exhaust manifold last?
- The Fulvia's original radiator would have to go - under-bonnet temperatures would be a big problem and of course you'd have to find space for the intercooler.
- Finally, I would say that off-boost performance would probably not be very impressive.
Desite all this I have a weakness for modifications as my readers probably know, so best of luck to whoever won the auction!
If you click on the link you will find some more pictures.
With my experience at Evolution Engineering which specialised in Lancia and FIAT, I have to say that this "kit" appears to have used various FIAT components - almost certainly from a Uno Turbo. At a glance it would seem to me that the problems would be formidable. Here are some of those that spring to mind:
- With 9.5/1 or 10.5/1 compression (1300/1600) one could run very little boost without meltdown ensuing rapidly, so special pistons would be required to lower the compression ratio.
- This problem would be exacerbated by the necessarily long inlet pipe (where would you run it?) which would mean lag and raised inlet temperatures
- Pressurised carburettor(s) would be very difficult to arrange, so electronic injection/management would be required. To install this would not be trivial; the cheapest approach would probably be to use a plenum chamber and single throttle body scrounged from another Uno Turbo; then of course there's mounting the sensors - oh yes and the small matter of calibration.
- Routing the exhaust, always a problem on a Fulvia would be rather tricky... and how long would that welded-up exhaust manifold last?
- The Fulvia's original radiator would have to go - under-bonnet temperatures would be a big problem and of course you'd have to find space for the intercooler.
- Finally, I would say that off-boost performance would probably not be very impressive.
Desite all this I have a weakness for modifications as my readers probably know, so best of luck to whoever won the auction!
A bientot
No comments:
Post a Comment